How To Install a Home Theater Sub woofer
There are three ways that you can connect an audio source to the subwoofer the first one is the most common which would be the LFE input most up-to-date receivers will have this type of output and this is actually using a crossover that's in your receiver and instead of the crossover that's built into this amplifier and how you connect that is using an RCA patch cord from your receiver and plug it into this jack in this position or this installation, this net or this dial down here would not be used you would not use the frequency or crossover adjustments.
When you're using the LFE input because all of those adjustments are done at the receiver location the second type of installation is your low-level right and left inputs and they would go into here this is for a receiver that doesn't have an L Fe input or output and in this case.
If you are interested In-Home theatre Read Here Reviews about best 5.1 speakers under 15000.
You would use your crossover in the lava sub and you would use this dial to adjust your different frequency ranges the last and probably the most probably not used all that often is the high level which is designed for a speaker to channel speaker setup this is where you take your speaker wires from your receivers your left and your right and they would go into the left and then also into the right side.
You'd do the same for the right side here this is where you wouldn't have used this application if you don't have a subwoofer output on your receiver for a stereotype of setting up what you have here on the bottom half of the amplifier is the volume so you can adjust the amount of output you want on your receiver again the frequency range you can adjust the sound how low or high the subwoofer goes the first which you see here is a phased switch and this is only critical if you have two subwoofers in your system.
If you do have two subwoofers you just want to make sure that each subwoofer is on opposite settings either 0 180 in a single subwoofer setting it doesn't matter which setting it's in the last switch that you see here is your power you have three settings one is in the off position and that would turn this power light to red and the subwoofer is not going to operate in this settings then you have them on.
There You go for the best home theater system under 15000.
Which is all the way to the right and that would turn this light to green and this subwoofer this amplifier would be an always-on ready state the middle setting which is the auto setting is an auto-sensing and what it's going to do is going to turn this light red and when there's an audio source present in one of these three inputs it'll turn green and the subwoofer will be active after that source has gone away or been turned off it will go into a sleep mode after a few minutes and turn the light red you also have the main power switch on and off that you can override any of these switches by turning this one on or off and then you have your power plug with your pues access here that you can check any fuse if you have problem with the power you also have a replacement fuse inside there to fixing the bond fuse problems and there also is a setting here for different voltage ha's in different countries you.
